was a bit crappy but after i changed the earth clamp to a 400amp clip with copper in the bite it welds pretty well (not so good on the 2mm sheets) the Ferm was a find while dropping off some stuff at the dump, i took it home and replaced the earth clamp as before, put new swan on it, tip and shroud, it now welds pretty good two, yet to run direct comparisons but bascially they appear the same to me but the question over the flux core in a mig that cannot have polarity reversed is bothering me.Ĭan you offer advice. The kende cost me only 40 quid with flux core. MAG with Flux cored arc welding uses heat generated by an electric arc to fuse base metal in the weld joint area. i have 2 welders, neither are top class but they both stick metal together so im happy learning on them, however one is a kende 105f flux core welder (no gas) and the other the Ferm 100 gas model (i dont have gas for it) anyway i dont need 2 so will probably sell one after a bit of playing, both seem ok welders to me but i was not sure if i could use flux core wire in the Ferm 100. Welds mild steel with a gasless, flux core wire electrode Welds up to 1/8 in. Reason im asking is that im just starting out and loving it. The use of flux core wire is more commonly associated with carbon steel welding. However, it is important to note that stainless steel is typically MIG welded using a shielding gas, such as argon, rather than flux core wire. With variable speed wire control and thermal overload protection, this flux wire. Yes, it is possible to MIG weld stainless steel with flux core wire. Set-up is easy for gasless flux-cored welding. This eliminates the need for gas and regulators that normal MIG welders require. The flux core provides a shield from any of the surrounding atmospheres. It’s an early welding technique and only used in the flux welder, which can also use a MIG set to feed shielding gas or solid gases. Hi, i have a Ferm 100 which is a gas mig but i want to use flux core with it, but there is no way to reverse the polarity so my question is, is it ok to use flux core in a mig that the polarity cannot be changed on. The Flux 125 Welder is a versatile flux core arc welder (FCAW) specifically designed to use self-shielding flux-cored welding wire. Flux core welding is a process denoted by FCAW (Flux Core Arc Welding).
0 kommentar(er)
